Applied Safety Engineering Assignment Example | Topics and Well Written Essays - 500 words

Applied Safety Engineering - Assignment Example a) Each employee must be provided fall protection by the employer on a scaffold that is greater than 10 feet elevation from the lower level. A qualified individual has to determine the possibility and safety giving fall protection for the workforce that is erecting or taking to pieces the supported scaffold. b) The toprail must be in between 38 and 45 inches (0.9- 1.2 meters). Midrail should be close enough to the halfway point between toprail and platform surface. Whenever a crosspoint of crossbracing is utilized as midrail, it has to be region of 20-30 inches (0.5-0.8 meters) on top of the work platform. d) Scaffold and its components should at least withstand a load that is 4 times the load that it was actually designed for. Suspension rigging of the scaffold should be at minimum 6 times the designed load. e) Prior to each and every work shift and following any situation that has the ability of compromising the structural integrity, a qualified individual has to examine the scaffold and the elements of the scaffold so as to check for any noticeable defects. h) An engineer is required to design scaffold that are not stationary at the time the workforce is working on them and the design of brackets on frames that are fabricated on the scaffold to be used to give support to the cantilever loads plus the workers. i) Access must be provided whenever the platform is greater than 2 feet above or lower than the point of access. Access that is direct is allowed in a situation that the scaffold is less than 14 inches horizontally and lesser than 24